NTNUJAVA Virtual Physics LaboratoryEnjoy the fun of physics with simulations! Backup site http://enjoy.phy.ntnu.edu.tw/ntnujava/
February 22, 2020, 09:08:43 am

The most important medicine is tender love and care. ..."Mother Teresa(1910-1997, Roman Catholic Missionary, 1979 Nobel Peace Prize)"

 Pages: [1]   Go Down
 Author Topic: Laser pumping (3 level)  (Read 27861 times) 0 Members and 1 Guest are viewing this topic. Click to toggle author information(expand message area).
Fu-Kwun Hwang
Hero Member

Online

Posts: 3085

 « Embed this message on: February 20, 2011, 05:42:07 pm » posted from:Taipei,T\'ai-pei,Taiwan

A laser is a device that emits light (electromagnetic radiation) through a process of optical amplification based on the stimulated emission of photons. The term "laser" originated as an acronym for Light Amplification by Stimulated Emission of Radiation.

A population inversion occurs when a system (such as a group of atoms or molecules) exists in state with more members in an excited state than in lower energy states. The concept is of fundamental importance in laser science because the production of a population inversion is a necessary step in the workings of a standard laser.

To understand the concept of a population inversion, it is necessary to understand some thermodynamics and the way that light interacts with matter. To do so, it is useful to consider a very simple assembly of atoms forming a active laser medium.

Assume there are a group of N atoms, each of which is capable of being in one of two energy states, either
# The ground state, with energy E1; or
# The excited state, with energy E2, with E2 > E1.
The number of these atoms which are in the ground state is given by N1, and the number in the excited state N2. Since there are N atoms in total,
$N_1+N_2 = N$
The energy difference between the two states, given by
$\Delta E_{12} = E_2-E_1$,
determines the characteristic frequency ν12 of light which will interact with the atoms; This is given by the relation
$E_2-E_1 = \Delta E = h\nu_{12}$,
h being Planck's constant.

If the group of atoms is in thermal equilibrium, it can be shown from thermodynamics that the ratio of the number of atoms in each state is given by a Boltzmann distribution:
$\frac{N_2}{N_1} = \exp{\frac{-(E_2-E_1)}{kT}}$,
where T is the thermodynamic temperature of the group of atoms, and k is Boltzmanns constant.

We may calculate the ratio of the populations of the two states at room temperature (T ≈ 300 K) for an energy difference ΔE that corresponds to light of a frequency corresponding to visible light (ν ≈ 5×1014 Hz). In this case ΔE = E2 - E1 ≈ 2.07 eV, and kT ≈ 0.026 eV. Since E2 - E1 ≫ kT, it follows that the argument of the exponential in the equation above is a large negative number, and as such N2/N1 is vanishingly small; i.e., there are almost no atoms in the excited state. When in thermal equilibrium, then, it is seen that the lower energy state is more populated than the higher energy state, and this is the normal state of the system. As T increases, the number of electrons in the high-energy state (N2) increases, but N2 never exceeds N1 for a system at thermal equilibrium; rather, at infinite temperature, the populations N2 and N1 become equal. In other words, a population inversion (N2/N1 > 1) can never exist for a system at thermal equilibrium. To achieve population inversion therefore requires pushing the system into a non-equilibrated state. --- from wikipedia:Population_inversion

This following a simulation for laser pumping.

There are three energy levels: E0=0,E1,E2 (E2>E1). You can use slider to change E1 and E2.
Use checkbox to set allowed energy between energy level.
chekc 0-1 means allow transition between energy level E0 and E1.
The probability to jump from E0 to E1 is proportional to $exp^{-(E1-E0)/kT}$

Pumping rate for ground state can be adjusted with slider (default value=0.5).

Laser pumping is the act of energy transfer from an external source into the gain medium of a laser. The energy is absorbed in the medium, producing excited states in its atoms. When the number of particles in one excited state exceeds the number of particles in the ground state or a less-excited state, population inversion is achieved.
You can uncheck 0-1 and check 0-2,1-2 (3 levels) to reach laser pumping condition.

Enjoy!

Embed a running copy of this simulation

Embed a running copy link(show simulation in a popuped window)
Full screen applet or Problem viewing java?Add http://www.phy.ntnu.edu.tw/ to exception site list
• Please feel free to post your ideas about how to use the simulation for better teaching and learning.
• Post questions to be asked to help students to think, to explore.
• Upload worksheets as attached files to share with more users.
Let's work together. We can help more users understand physics conceptually and enjoy the fun of learning physics!
 laserpumping.gif (173.13 KB, 731x289 - viewed 7272 times.) Logged
diinxcom
watchlist
Jr. Member

Offline

Posts: 25

Designer

 « Embed this message Reply #1 on: December 14, 2014, 05:25:35 pm » posted from:,,Satellite Provider

-*-
I confused
 Logged
MikeFreud
Newbie

Offline

Posts: -6

 « Embed this message Reply #2 on: January 10, 2015, 04:58:14 pm » posted from:Kannur,Kerala,India

If a laser is continuously emitting light, then there must be power to replenish that lost energy in such a way that the laser action can continue. The power must maintain the necessary population inversion to keep the laser process going, and that implies a pumping mechanism to elevate electrons to that metastable state . The use of helium to "pump" electrons into a metastable state of neon in the helium-neon laser is an example of such a mechanism.
 Logged
 Pages: [1]   Go Up
The most important medicine is tender love and care. ..."Mother Teresa(1910-1997, Roman Catholic Missionary, 1979 Nobel Peace Prize)"