NTNUJAVA Virtual Physics LaboratoryEnjoy the fun of physics with simulations! Backup site http://enjoy.phy.ntnu.edu.tw/ntnujava/
September 22, 2019, 05:01:51 am

Simplicity is the ultimate sophistication. ..."da Vinci (1452-1519, Italian artist, sculptor, painter, architect, engineer and scientist) "

 Pages: [1]   Go Down
 Author Topic: Pendulum (Why the angle need to be less than 5 degree --- is it necessary?)  (Read 21194 times) 0 Members and 1 Guest are viewing this topic. Click to toggle author information(expand message area).
ahmedelshfie
Moderator
Hero Member

Offline

Posts: 954

 « Embed this message on: April 27, 2010, 07:37:26 pm » posted from:,,Brazil

This applet created by prof Hwnag
Modified by Ahmed
Original project Pendulum (Why the angle need to be less than 5 degree --- is it necessary?)

A small angle vibration of pendulum can be approximated modeled with simple harmonic motion (SHM).
The equation is

d2θ/dt2= - g* sin (θ)/L ≒ -(g/L)θ
And we get a SHM (ignore difference between  sin (θ) and θ).
Some text book indicated that the angle should be less than 5 degree for the above approximation to be valid.

Why the angle should be less than 5 degree? What is the condition or restriction to set the angle to be less than 5 degree?
Can we use 6 degree? Can we use 10 degree?

The question should be asked is "what is the error if the initial angle is 10 degree?".
Under what condition the angle of the pendulum should be less than 5 degree?

The following applet let you adjust the initial angle for the pendulum,
click right error button to start the swing.
The theorical value for gravity g=9.8 is used.
T(SHM) is calculated from 2*π *√(L/g).
The applet will re-measure the period T(real) for each half cycle.
Then, g(calc)= 4*π2*L/T2(real) is calculated , with error =100*(1-g(calc)/g) % is displayed.

The initial angle for the following applet is 20 degree and the error is less then 2%.
You can set to other angle after several period has passed (for better average value for period).
For example: 5 degree will give you almost less than 0.2% error (after several swings).

You can change the initial angle several times and the plot at the right will show you "error vs. angle".

I found a lot of students doing similar real experiment in the lab and when they found the error was too large, say 8 %. They will claim that it is due to the initial angle was too large (may be 10 degree).
But even 20 degree will cause less than 2% of error. Error was coming from some other measurement.

You can drag the pendum directly to change initial angle and length when the simulation is paused!

Embed a running copy of this simulation

Embed a running copy link(show simulation in a popuped window)
Full screen applet or Problem viewing java?Add http://www.phy.ntnu.edu.tw/ to exception site list