NTNUJAVA Virtual Physics Laboratory
Enjoy the fun of physics with simulations!
Backup site http://enjoy.phy.ntnu.edu.tw/ntnujava/

Information about this web site => Question related to Physics or physics related simulation => Topic started by: stevenfrank38 on April 29, 2011, 08:33:09 am



Title: How to use Visual Studio/Visual Basic6.0
Post by: stevenfrank38 on April 29, 2011, 08:33:09 am
This step-by-step article describes how to use the Microsoft Visual Studio .NET or Microsoft Visual Studio 2005 native debugger to debug a Microsoft Visual Basic 6.0 DLL when it is called from an ASP.NET application.

To debug Visual Basic applications, use one of the following methods:

    * Use the Visual Basic development environment.

      When you debug in the development environment, you use P-code. P-code is an interpreted language that permits you to debug in the development environment.

      -or-
    * Use the native debugger if problems do not appear when you debug in the Visual Basic development environment, but problems do appear in the compiled version.

This article describes how to use the second method to debug a Visual Basic 6.0 DLL that is being used in ASP.NET. You debug the DLL by using the same binary that the DLL runs with (not including any optimizations). This creates an execution that is easier to debug than the P-code that you receive when you debug in the Visual Basic development environment.


Back to the top
Requirements

The following list outlines the recommended hardware, software, network infrastructure, and service packs that are required:

    * Microsoft Visual Studio .NET or Microsoft Visual Studio 2005
    * Microsoft Visual Basic 6.0
    * Microsoft Internet Information Services (IIS) 5.0 or later

This article assumes that you are familiar with the following topics:

    * Microsoft Visual Basic .NET or Microsoft Visual Basic 2005 syntax
    * Microsoft Visual Basic 6.0 syntax
    * Microsoft Visual Studio .NET or Microsoft Visual Studio 2005 environment

Back to the top

Read more..
http://support.microsoft.com/kb/811658


Title: Re: How to use Visual Studio/Visual Basic6.0
Post by: BecasConacyt on June 20, 2011, 04:05:52 am
Cool post!... -*-


Title: Re: How to use Visual Studio/Visual Basic6.0
Post by: HodgeMorin on November 10, 2011, 12:47:35 pm
Your post is really helpful to understand all the basics of VB for those who are new to use it.
-*-


Title: Re: How to use Visual Studio/Visual Basic6.0
Post by: signnit-66 on September 20, 2012, 10:55:48 am
กดกันเลยย